Cleaning method of busbar processing machine

Any machine will produce a lot of dust and product debris after being used for a long time. If it is not cleaned in time, it may affect the normal operation of the machine. Therefore, for busbar processing machines, in addition to good maintenance work, cleaning work is also key. .
1. Hot oil cleaning method: Due to long-term use, bearings hardened by soft dry oil or anti-rust paste should be immersed in thermal engine oil at 100-200°C, clamp the bearing with pliers, and use a brush to clean the oil stains on the bearing. Soft dry oil or anti-rust paste melts when heated to 100-200°C, and is easily washed out from the gaps in the bearing. Sometimes it is only necessary to shake the bearing several times in the oil. Oil dirt will also flow away from the gaps. When cleaning the radial spherical bearings of old busbar processing machine motors or imported motors, the balls, ball frames, and inner rings should be turned laterally out of the outer ring and then immersed in hot oil. When cleaning short cylindrical roller bearings, the The rollers, ball cage, inner and outer rings should be disengaged. During hot oil cleaning, the oil temperature should not exceed 20°C. If an open flame is used for direct heating, care should be taken to avoid burning the oil. The bearing should be suspended in the oil pan. If it sinks to the bottom, it will cause overheating and reduce the hardness.
2. General cleaning method: Soak the bearing in kerosene for 5-10 minutes. Hold the inner ring with one hand and turn the outer ring with the other hand. The dry oil or anti-rust paste on the bearing will fall off. Then put the busbar processing machine bearing into cleaner kerosene, rinse it with a fine and soft brush, clean the oil in the balls and gaps, put it in gasoline to clean it once, take it out and put it on a clean paper . When cleaning radial spherical ball bearings and short cylindrical roller bearings, the balls, ball frames, inner rings and outer rings should be separated and cleaned. The bearings installed on the busbar processing machine shaft are mainly cleaned by spraying oil or spraying with an oil gun. For easy-to-clean oil stains, first use kerosene and then gasoline; for oil stains that are difficult to clean, first use 100-200℃ Rinse with hot engine oil or spray with an oil gun, then clean with gasoline. Be sure not to use sharp objects to scrape the bearings: hardened grease or rust will prevent damage to the smoothness of the rolling body and groove ring of the bearing. Wipe the cleaned bearings dry with a clean cloth.
Therefore, I would like to remind everyone that when using the busbar processing machine again in the future, you must always do a good job in cleaning it.